search

Fusion CS-AT1100 User Manual

Browse online or download User Manual for Car audio amplifiers Fusion CS-AT1100. Fusion CS-AT1100 User's Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
    • Rated. / 5. Based on customer reviews
Page view 0
ACTIVE TUBE
SPECIFICATIONS
CS-AT1100
PeakPower(Watts) 360
RatedPower(Watts) 120
FrequencyResponse 36Hz-250Hz
LowPassFilter(Variable) 40Hz-250Hz
Tuning BassReex
WooferSize 10”
Fuse 20A
Dimensions(mm) 559(l)x306(w)x306(h)
22-1/32x12-1/16x12-1/16”
CS-AT1100
www.fusionelectronics.com
CONTROL DESCRIPTIONS
LEVEL
Thisallowstheadjustmentoftheamplierlevelofthesubwoofer.
Turnclockwisetoincreasethelevel.Ifthesoundbecomesdistorted
reducethelevel.
LOW PASS FILTER (LPF)
This allows the adjustment of the highest frequency the Active
Tubewillproduce.Thisshouldbeadjustedtoblendwithyourmain
speakers.Typically,thiswillbesettoaround100Hz(approximately
thecentralpositionofthecontrolknob).
REMOTE LEVEL CONTROLLER
Whenconnected,thisallowsfurthercontroloverthelevelfroma
remotelocation,usingthesuppliedlead.
INSTALLATION
Makesure the Active Tube is rmly xed in your vehicle. Check
beforedrillingorcuttingholes.DONOTworkneargastanks,fuel
lines,hydrauliclinesorelectricalwiring.
DONOTmounttheActiveTubeinsuchawayastopinchordamage
thewires.
Make sure everything is rmly connected, before attaching the
+12Vwire.Ensurethe+12Vwireisfusedascloseaspossibletothe
battery.Alwaysuseafusewiththerecommendedrating.
DISCLAIMER
AlwaysensuretheActiveTubeissecurelyattached,toavoidmovement.FUSIONacceptsnoresponsibilityfordamageorinjuryinrelation
toinappropriatesecuringofthisproduct.
WIRING
• Connectthegroundwiretothevehiclerst(cleandirtandpaint
tobaremetal).
• Connecttheremoteon(bluewire).
• ConnecttheRCAcablesifapplicable,OR
• Connectthespeakerlevelwirebysplicingintotheheadunits
speakerwires.SeeNote1onreverse.
• Connecttheremotelevelcontrollerwiththesuppliedlead.
• Connectthe12volt(redwire)tothepositivebatteryterminal.
• Checkallconnections.
Page view 0
1 2

Summary of Contents

Page 1 - ACTIVE TUBE

ACTIVE TUBESPECIFICATIONS CS-AT1100PeakPower(Watts) 360RatedPower(Watts) 120FrequencyResponse 36Hz-250HzLowPassFilter(Variable) 40Hz-

Page 2

PUBLISHEDBYFUSIONELECTRONICSLIMITED:©Copyright2010byFUSIONElectronicsLimited.Allrightsreserved.Specicationsanddesignaresubjectto

Comments to this Manuals

No comments
  • Shanghai koolspace Griffin Technology ARX Intelbras Dream-property
  • Behringer Microphone accessories APRILIA Motorcycles GigaTent Unknown Belkin PowerLine network adapters Hoshizaki Juice makers
  • Westinghouse VR-6025Z Aeg HG654440SM Whirlpool ADP 490 IX Sony ICD-UX513F Frigidaire FFGF3054TS
  • Sony GTK-XB7 User Manual Dell Inspiron 1428 User Manual Philips SE7452B User Manual Elenco Soldering Station User Manual Ge JRS06BJBB User Manual